pierre romet / OBD2_freematics

Commit 96921e2799a433cce849662c55adff033be6d7c4

Authored by yessine kammoun
1 parent 38035780

add getting started with code

Showing 1 changed file with 2 additions and 2 deletions   Show diff stats
Inline Side-by-side
@@ -2,7 +2,7 @@ @@ -2,7 +2,7 @@
2 2
3 ## Introduction 3 ## Introduction
4 4
5 -The goal of this project is to develop a kind of datalogger collecting different peaces of information from OBD-II (On-board diagnostics), GPS, and IMU (Inertial measurement unit) and to store them into a CSV file in an SD card. 5 +The goal of this project is to develop a kind of datalogger collecting different pieces of information from OBD-II (On-board diagnostics), GPS, and IMU (Inertial measurement unit) and to store them into a CSV file in an SD card.
6 The developped datalogger has to meet certain requirements to operate. These are: 6 The developped datalogger has to meet certain requirements to operate. These are:
7 7
8 * [Freematics ONE+](https://freematics.com/products/freematics-one-plus/) board. 8 * [Freematics ONE+](https://freematics.com/products/freematics-one-plus/) board.
@@ -13,7 +13,7 @@ The developped datalogger has to meet certain requirements to operate. These are @@ -13,7 +13,7 @@ The developped datalogger has to meet certain requirements to operate. These are
13 ## How to run the project ? 13 ## How to run the project ?
14 14
15 Once you fulfill all the needs above, you clone the depository then you load the `./FreematicsOBD/datalogger/simple_obd_test.ino` using 15 Once you fulfill all the needs above, you clone the depository then you load the `./FreematicsOBD/datalogger/simple_obd_test.ino` using
16 -the Freematics Arduino Builder. You choose the appropirate target board. Tick `Rebuild Core` and `Rebuild Llibs`. Finally, connect your board to the computer, click on refresh then click on the last added serial port to upload the project. 16 +the Freematics Arduino Builder. You choose the appropirate target board. Tick `Rebuild Core` and `Rebuild Libs`. Finally, connect your board to the computer, click on refresh then click on the last added serial port to upload the project.
17 Now, you can connect the device to the OBD port of the vehicle. Turn on the engine and wait until you hear a beep from the board buzzer. At this time, the board is ready to collect information. If the buzzer does not work, you just reconnect the board and wait again. 17 Now, you can connect the device to the OBD port of the vehicle. Turn on the engine and wait until you hear a beep from the board buzzer. At this time, the board is ready to collect information. If the buzzer does not work, you just reconnect the board and wait again.
18 If you want to see the data written in SD card in real time and visualize them on your screen. You may need a longer USB wire. However, 18 If you want to see the data written in SD card in real time and visualize them on your screen. You may need a longer USB wire. However,
19 you need to set `USE_SERIAL` to 1 (otherwise 0) which exists in the `./FreematicsOBD/datalogger/simple_obd_test.h`. 19 you need to set `USE_SERIAL` to 1 (otherwise 0) which exists in the `./FreematicsOBD/datalogger/simple_obd_test.h`.